Vape Cartridge TPD — for importers
Buyers come to us for vape cartridge after a bad quarter: dead stock on one side, empty shelves on the other. The cause is usually the same, an assortment built from a catalogue instead of from sell-through data. This page explains how we rebuild that balance for B2B buyers.
Published 12 January 2025 · VapeWholesaleHub · Reading time 8 min
Simple habits that lift velocity
We work with B2B buyers who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.
Counter space is finite. Three well-chosen SKUs outsell nine crowded ones, and the empty space signals a curated range rather than a clearance table.
Shelf position decides velocity as much as price. Keep vape cartridges at eye level, one facing per SKU, and rotate the trial line every quarter so the display keeps earning attention.
Unit price versus landed cost
Custom printing raises the unit price and lowers the marketing cost. For B2B buyers the break-even is usually reached on the second or third repeat order, not the first, so we quote both branded and neutral options.
The cheapest way to lower your cost per unit is usually to remove a SKU, not to negotiate a discount. Fewer lines means larger runs, fewer changeovers and a better price at the same quality.
Building an assortment that actually turns
The first question we ask is not what you want to spend. It is what your customer already buys. Answer that and the vape cartridge list writes itself; skip it and you end up with a pallet of stock that photographs well and sells badly.
We keep a short list of approved configurations for vape cartridges. Anything outside that list is possible, but it becomes a custom run with a custom lead time, and we quote it as such rather than pretending everything is standard.
- Private label files archived for future rebrands
- Standing reorder schedule with a fixed cut-off
- Reference sample retained from every batch
- Seven-day defect reporting with replace-or-credit
- Document pack prepared per destination market
- Batch codes traceable from carton back to production date
What we test before a carton is sealed
Battery safety is not a marketing line. Cells are matched by capacity and internal resistance before assembly, charging boards are checked for cut-off voltage, and any unit that fails the cut-off test never reaches packing.
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
Specification summary
| Volume | 2.0 ml |
| Core | Mesh |
| Resistance | 1.2 ohm |
| Thread | Press-fit |
| Airflow | Bottom |
| Packaging | Tube |
| Minimum order | 200 units per SKU, mixed cartons allowed |
| Lead time | 12 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
How long does production take?
Around 25 working days after artwork approval for stock configurations, plus transit. Custom runs add roughly a week for tooling and a physical dummy. We confirm the date in writing on the order acknowledgement.
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 300 units. We would rather you handle the sample than approve a specification from a photograph.
What is the minimum order for vape cartridge?
Standard configurations start at 300 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 800 units because of setup time on the line.
Related reading
Need a quotation on vape cartridges?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz