Vape Cartridge contract and PO terms — a deep dive
Buyers come to us for vape cartridge after a bad quarter: dead stock on one side, empty shelves on the other. The cause is usually the same, an assortment built from a catalogue instead of from sell-through data. This page explains how we rebuild that balance for B2B buyers.
Published 02 April 2026 · VapeWholesaleHub · Reading time 6 min
Sell-through notes for the shop floor
A vape cartridge programme only works when three numbers agree: your shelf price, your reorder cycle and your defect tolerance. Change one and the plan moves. We build assortments around those three and we say so up front rather than after the invoice.
Shelf position decides velocity as much as price. Keep vape cartridges at eye level, one facing per SKU, and rotate the trial line every quarter so the display keeps earning attention.
Staff knowledge converts better than any poster. If your team can explain the difference between two coils in one sentence, the step-up SKU sells itself.
Building an assortment that actually turns
Colour range is where assortments quietly die. Six finishes look impressive in a brochure and disastrous on a shelf with 40 cm of space. We recommend two finishes per core SKU and let the trial line carry the novelty.
We keep a short list of approved configurations for vape cartridges. Anything outside that list is possible, but it becomes a custom run with a custom lead time, and we quote it as such rather than pretending everything is standard.
Getting the documents right
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
Artwork approval is a two stage process: a digital proof for text and layout, then a physical dummy for colour and finish. Skipping the dummy is the single most common cause of a reprint.
- Reference sample retained from every batch
- Standing reorder schedule with a fixed cut-off
- Mixed SKU cartons to spread first-order risk
- Batch codes traceable from carton back to production date
- Specification locked in writing before production starts
- Document pack prepared per destination market
After-sales, replacements and reorders
For private label accounts we hold the artwork files and the approval record. Rebranding a line eighteen months later is then a file update instead of a redesign.
The replacement policy is deliberately simple: report within seven days of delivery with photos and the batch code, and we replace or credit at the next shipment. We do not argue about a defect we can see in a photograph.
Specification summary
| Volume | 1.0 ml |
| Core | Cotton |
| Resistance | 1.2 ohm |
| Thread | 510 thread |
| Airflow | Bottom |
| Packaging | Tube |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 12 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
What documents come with a shipment?
Commercial invoice, packing list, and the certificate pack for your market: test reports, declaration of conformity and safety data sheets. We send scans before dispatch so your broker can pre-clear the file.
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 100 units. We would rather you handle the sample than approve a specification from a photograph.
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
Related reading
Need a quotation on vape cartridges?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz